LENGE PTFE Microporous Membrane Pleated Filter Element

  • Status: Avai
Contact

Order by phone ( 8AM - 8PM )

Hotline 0901237008

PTFE microporous membrane pleated filter element is made of natural hydrophobic polytetrafluoroethylene (PTFE) membrane and polypropylene material parts by advanced hot-melt sealing technology in a controlled Class-100 clean environment without any adhesive and surfactant and meets the technical requirements of the national standard of the people's Republic of China GB / T 34244-2017 filter cartridge for liquid sterilization.

The material of filter element components:
Filter material: Natural hydrophobic PTFE membrane

Supports/Diversion: PP

Core/Cover/End cover/End caps: PP

Sealed leads/Fins: PP, Built-in stainless steel

O-Ring: 222,226 silicon rubber etc.

Sealing technology: Hot melt without adhesives

 

Characteristics and features

 

  • Excellent high-tem resistance and extensive chemical compatibility.

  • All the compositions reach up to the requirement of the biological testing characteristics of USP Class 6 plastic products at 121℃ and the food contact materials listed in the relevant regulations of Chapter 21 of the Federal Regulations of the United States (CFR). They also conform to the requirements of China's "Standard for Hygienic Safety Evaluation of Equipment and Protective Materials in Drinking Water" (2001) for drinking water transport and distribution equipment.

  • 99.99995% bacteria retention in gas and liquid.99.99995% of all kinds of phages, bacteria and particles above 0.01μm were retained during gas filtration.

  • The sampling of filter element successfully passed the bacterial challenge test required by regulations, LRV≥7.Integrity can be maintained after repeated high-pressure disinfection.

  • Each filter element should pass the integrity test before leaving the factory. The limitations of integrity testing were correlated with the results of bacterial challenge experiments.

  • It is manufactured under ISO 9001 and ISO 14001 systems and Class 100 environment.

  • Production and usage are traceable.

  • Resistant to repeated steam sterilization.

  • large air flow, high efficiency and small volume.

 

Technical specifications and operating parameters

Size

Diameter: 2.75" (69 mm)

Length: 5"/10"/20"/30"/40" etc.

Filtration Area

Single 10" filter element is about 0.65m²

Minimum Bubble Point of Integrity Test Data

0.22μm: ≥ 0.13MPa (Import)

≥ 0.1MPa (Chinese)

0.45μm: ≥ 0.06MPa 23°C

60:40IPA: water(V:V)

Typical Flow Rate

0.1um≥180Nm3 /h

0.22μm≥330Nm3 /h

0.45μm≥400Nm/h,

(P=0.2MPa, ΔP=0.01MPa, 20°C, 10" length)

Accumulated Steam Sterilization Time

121°C, 100 hours

140°C, 40 hours

Under experimental conditions

Maximum Differential Pressure

Positive:0.4MPa

Negative:0.2MPa

Recommended Service Life for Air Filtration

12 months for 60°C compressed air filtration

6 months for 80°C breathing port filtration


Typical application

  • Breathing port filtration of WFI storage tank.

  • Air inlet and exhaust filtration of large-scale fermentation tank.

  • Breathing port filtration of medical intermediate storage tank.

  • Filtration of instrument gas in pharmaceutical industry.

  • Vacuum barrier of autoclave.

  • Transmission and filtration of air and other gases.

  • Gas filtration for aseptic packaging.

  • Sterilization and filtration of compressed air and CO2 in food and beverage industry.

  • Filtration of corrosive chemicals.

popup

Số lượng:

Tổng tiền: